Fitting a Traction Bar? How To?
BeetleBug:
No need to drill those extra holes in your inner fender if you have a hole there already;
Remove the bracket and flip so that you use the bend inwards and you`re good to go. Works well.
[ Attachment: You are not allowed to view attachments ]
[ Attachment: You are not allowed to view attachments ]
Best rgs
BB
BeetleBug:
Found a picture that explains it a bit better;
Make it easy :)
[ Attachment: You are not allowed to view attachments ]
Best rgs
BB
Zach Gomulka:
Ahh that makes more sense! Good thinking!
javabug:
How does that hole hold up after a while, though? I'd hate to have to bodywork that area eventually.
BeetleBug:
Quote from: javabug on March 03, 2010, 01:26:44 am
How does that hole hold up after a while, though? I'd hate to have to bodywork that area eventually.
Far better than the thin metal above. Two layers of metal makes it strong and besides, you`re not supposed to tighten the traction bar even though I suspect quite a lot of people do so.
Best rgs
BB
Navigation
[0] Message Index
[#] Next page
[*] Previous page