BRM wheel studs/nuts

<< < (3/3)

andrewlandon67:
Quote from: richie on May 15, 2020, 07:35:41 am

If you are even thinking about using slicks then use press in studs on rear, on front screw in studs with some thread lock work fine

cheers Richie


Quote from: leec on May 15, 2020, 15:32:40 pm

Agree, press in studs are far superior to the screw in. I had the machine shop spot face the back of the drum so the stud pressed in 100% square to the face of the disc/drum. That also adds a little clearance from the back of the stud to the internals of the brake drum

Lee


Thanks for the advice! I guess for the time being I'll use what I have and save up for some better press-in studs and nuts to go with them.

Navigation

[0] Message Index

[*] Previous page