Engine seal tool

[danny gabbard]

I made these to help straighten engine seal channels. Just tap them through and open up any crushed area to help slide new rubber through. Tool may need a little fileing because of any difference in width. there 15.00 plus shipping. They are made of steel.

[Fasterbrit]

Awesome 

[javabug]

Any plans to make one for the trunk and decklid seal channels?

[stealth67vw]

Any plans to make one for the trunk and decklid seal channels?

X2

[danny gabbard]

In the works to make a tool for front and rear seals. Would like to sell a few of these first to get some of my money back, If ya know what I mean.

[glenn]

I made these to help straighten engine seal channels. Just tap them through and open up any crushed area to help slide new rubber through. Tool may need a little fileing because of any difference in width. there 15.00 plus shipping. They are made of steel.

Can you post this in the Samba classified? I'd like to point some people to it and it should generate some sales.

[javabug]

I'll buy the pair if you make the other one.

[danny gabbard]

I made these to help straighten engine seal channels. Just tap them through and open up any crushed area to help slide new rubber through. Tool may need a little fileing because of any difference in width. there 15.00 plus shipping. They are made of steel.

Can you post this in the Samba classified? I'd like to point some people to it and it should generate some sales.

Hi and thanks Glenn. Its under general parts on the samba.

[glenn]

Got it: http://www.thesamba.com/vw/classifieds/detail.php?id=1273083

[draven898]

ill be sending a money order dannys way friday !

[danny gabbard]

That always sounds good!

[draven898]

danny pm