|
Title: Berg linkage & repro 36hp fan housing. Post by: JS on February 19, 2007, 19:19:35 pm My repro 36hp fan housing does not have the nuts for the original coil mount welded in. Will the berg linkage work with only two bolts?
How did you guys solve the problem? Title: Re: Berg linkage & repro 36hp fan housing. Post by: Harry/FDK on February 19, 2007, 19:41:07 pm Get Thread inserts in the fan housing. Expensive but a clean look.
Title: Re: Berg linkage & repro 36hp fan housing. Post by: JS on February 19, 2007, 20:53:23 pm This might just be a case of me being stupid, but how do i get threaded inserts inside the housing?
Title: Re: Berg linkage & repro 36hp fan housing. Post by: deano on February 20, 2007, 04:51:13 am You might also find that when using some repro 36hp fan shrouds, and the Berg linkage, is that the upper two generator backing screw holes are not even level, which makes bolting up the Berg linkage almost impossible (the linkage is no longer level with the engine). Something to think about.... Go Thing fan housing.
Title: Re: Berg linkage & repro 36hp fan housing. Post by: Zach Gomulka on February 20, 2007, 04:55:49 am You can slot the holes for the linkage mount as well.
Title: Re: Berg linkage & repro 36hp fan housing. Post by: Jon on March 13, 2007, 10:04:27 am Use pop rivet threads JS, easy... or weld a nut in there.
Title: Re: Berg linkage & repro 36hp fan housing. Post by: JS on March 13, 2007, 16:49:26 pm Thanks for the advice guys, for the coil mount/third bolt iŽll use this thing.
http://www.biltema.no/products/product.asp?iSecId=885&iItemId=80858 deano, the linkage that i have is already modified in the center hole to fit the repro fanhouses. Title: Re: Berg linkage & repro 36hp fan housing. Post by: bullitt on March 15, 2007, 19:29:26 pm did the work last week. pop threaded rivets will do perfectly
|