|
Title: Ghia rust repair Post by: danny gabbard on June 08, 2010, 17:55:40 pm The new and old peice and the hole that was cut out and ground and filed
Title: Re: Ghia rust repair Post by: danny gabbard on June 08, 2010, 17:57:21 pm Welded in and ground down
Title: Re: Ghia rust repair Post by: danny gabbard on June 08, 2010, 17:58:34 pm Shot of the inside.
Title: Re: Ghia rust repair Post by: Speed-Randy on June 08, 2010, 18:30:11 pm Hey Danny, you need to drill a hole in the cross center to drain water, That is a nice peice right there
Title: Re: Ghia rust repair Post by: jaqo on June 10, 2010, 00:16:07 am I have a question - hope you can help.
i can see you seam welded this thing - how do you prevent it from warping? Title: Re: Ghia rust repair Post by: danny gabbard on June 10, 2010, 03:04:22 am Any time you weld or heat panels up they warp or move around some. Now to your question, If you grind weld down to same thickness as the material your welding and hammer lightly on seams of weld it will start stretching the welds that shrank from welding and stretch alittle and bump with dolly till low spots go where you tell them. I hope that helps a little.
Title: Re: Ghia rust repair Post by: Harry/FDK on June 17, 2010, 19:49:22 pm 8) 8) 8)
|