|
Title: Valve angle in CB competition eliminators Post by: Tobi/DFL on February 04, 2011, 10:02:39 am Hi!
I want to cut valve pockets in my pistons. Does anybody know the correct angle of the valves in a CB competition eliminator head? Thanks! Tobi Title: Re: Valve angle in CB competition eliminators Post by: dangerous on February 04, 2011, 22:16:00 pm Always double check YOUR valve location and angle,
but it should be close to 9 degrees. Title: Re: Valve angle in CB competition eliminators Post by: TexasTom on February 05, 2011, 01:40:23 am I thought T1s used an 8* valve angle, or was that for the T2/4?
Title: Re: Valve angle in CB competition eliminators Post by: Martin on February 05, 2011, 08:17:20 am last set i measured were 9.5 deg
Title: Re: Valve angle in CB competition eliminators Post by: Tobi/DFL on February 05, 2011, 10:47:13 am Thanks everybody!
I measured mine with just a little more than 9 degrees so that should be right. Now the fun part begins... ;) Tobi Title: Re: Valve angle in CB competition eliminators Post by: Type1/DVK on February 05, 2011, 16:28:25 pm and anyone that knows the original or 044 heads? the same? thanks
Title: Re: Valve angle in CB competition eliminators Post by: Roman on February 05, 2011, 17:51:55 pm The stock, 041 and 044 heads has 9.5 degrees (or as it says in the stock manual, 9 degrees 30 minutes).
|