|
Title: merged size Post by: speedwell on February 07, 2011, 13:41:52 pm may be a stupid question ::)
Somebody could give me the various measures for those in inches and centimeter i know there's 1-1/2" 1-5/8" 1-3/4" i've collected yesterday a merged exhaust for the 1968cc the inside tube measurement is 38mm thx in advance fabs Title: Re: merged size Post by: Nico86 on February 07, 2011, 13:53:58 pm Just convert inches to mm.
1-1/2" = 38.1mm 1-5/8" = 41.3mm 1-3/4" = 44.5mm Or maybe you are asking for the length of the tubes and the length of the merged section ? Title: Re: merged size Post by: speedwell on February 07, 2011, 14:16:36 pm thx nico ;)
Title: Re: merged size Post by: Zach Gomulka on February 07, 2011, 15:17:38 pm Headers are measured by their outside diameter. So if it's 1 1/2" on the ID you have a 1 5/8" (OD) header.
Title: Re: merged size Post by: speedwell on February 07, 2011, 15:55:13 pm Headers are measured by their outside diameter. So if it's 1 1/2" on the ID you have a 1 5/8" (OD) header. it's 41 mm outside zach that header will be good for my 1968cc ??? if i'm used 40x37.5 mm heads Title: Re: merged size Post by: Zach Gomulka on February 07, 2011, 17:15:33 pm Should work great ;)
Title: Re: merged size Post by: speedwell on February 14, 2011, 19:01:14 pm stupid question ??? there is any fitment difference between the 1 3/8" and the 1 5/8" ??? the muffler would be maybe an 1 3/8" and the header is 1 5/8" , any problem with the flange ???
thx fabs Title: Re: merged size Post by: nicolas on February 15, 2011, 19:47:07 pm stupid question ??? there is any fitment difference between the 1 3/8" and the 1 5/8" ??? the muffler would be maybe an 1 3/8" and the header is 1 5/8" , any problem with the flange ??? thx fabs same flange and no problem. you could even fit your single quiet pack if it had its smaller flange and not the big one. and just to be sure, yes it is a 1 5/8 and it will work great for your plan. all you may need is a set of gaskets that are the correct size. ;) Title: Re: merged size Post by: speedwell on February 15, 2011, 19:57:36 pm thx nico ;)
Title: Re: merged size Post by: DKK Ted on February 16, 2011, 08:02:30 am I noticed the head flanges are thick, maybe a Berg header? Nice header though!
Ted |