|
Title: Need Cam Help Post by: Derjava66 on April 21, 2011, 04:14:17 am Hey Guys I tried searching for this info but had no luck, A friend of mine gave me a fresh 1914 that had been sitting unfinished on his garage floor for past 4 or 5 years. It had some rust in the new barells and none of the case holes were covered so I decided a full rebuild was in order. I split the case today and was hoping you guys might know what cam I have. The casting numbers are as follows.
CWC EP12 C4 D4 And it has 11 stamped on the front of it. I'm thinking maybe its an engle 110 but it would be nice to know for sure. Thanks in Advance Eric Title: Re: Need Cam Help Post by: K-Roc on April 21, 2011, 05:28:27 am It Could be a CB 2211 cam, they stamp their cams with the last 2 digits of the part number.
K-Roc, Title: Re: Need Cam Help Post by: Derjava66 on April 21, 2011, 05:45:58 am If it is that is a Huge cam for a 1914 with stock heads :o
Title: Re: Need Cam Help Post by: Torben Alstrup on April 21, 2011, 16:21:03 pm Well, yes and no. But that doesnt men that someone opted for that solution ;) If the heads are untouched they would restrict power a good deal. if the heads are ported well, it could make for a nippy little thang ;D
T Title: Re: Need Cam Help Post by: Derjava66 on April 21, 2011, 19:24:34 pm I don't want to mention the name of the builder but he was told it was for a baja. They told him torque was important and he based the cam choice on that. Just seems an odd choice to go with stock heads in a non stroker motor. That cam looks to a high RPM power maker and the rest of the motor wasn't built for that.
|