The Cal-look Lounge

hey all.. after over a years brake with new house, new job and a little girl i finally have time to go to the garage agin.

at the last race last year i burned a cylinder and piston and did not take the engine apart before new year. last setup i had was turbo with carburator but the setup was to small for my needs so i decidet to change to efi and running on methanol.
ordered some new cylinders and cp pistons from geers and when i talked to him he told me he had a nice new Autocraft case he would sell to me.. so anfter he did some work on it he sent it to me so naw i have most of the parts to start on the engine build.
my new turbo is a garrett gt4202r with a stainless tial exhaust. got 8 2300ml injectors from leif nystrøm and the efi box will be a costum made one from fjm here in denmerk. (has a wery good datalogging system)

also need a new gearbox and think it will be a mendeola with CV spool setup.

will try to have this page updated and upload pictures when there is progress..

engine setup so far is.

autocraft case
86mm scat crank
pauter rods
geers cylinders and cam.
cp pistons
heads will be my old CE heads for now and maby later some strib dominator or other all race heads.

Now that will be Sweet, looking forward to seeing this Build up...... ;D

Updates?

yes.. got my dog gear from finland today so will send them over to dave folts who is building my new gearbox.
so soon it will be on its wheels agin and i will start to build the turbo system.

[attachment=2][attachment=2]

new gearset from finland.. ;D ;D ;D ;D

Any updates with the car? Is Dave Folts building your tranny?

yes dave folts are building my new gearbox. went with a 091 box with his axel setup. have alot of parts on order from marty staggs. turbosmart stuff, big weldon fuel pump and bends for my ned exhaust. so as soon i got pictures from dave i will upload them..

i will start building my long block in a week or so. will have to work on my endplay of the crank. my new autocraft case is with all BMW mains so they need alittle work.

my ecu will be the new KMS with datalogger so looking forward to try it out.

hey.. after a long time away from the garage with my dad passing away and had to deal with his shop i am back in there

had time to put in my nice 091 dave folts box and it is now redy for an engine. also have put in a bigger tank, new dash and starting to build in my AIM datalogger i got from Marty Staggs. He have been wery helpful to get me the right parts i needet and dave had it all spiped over with the box.

have just orderet a new flywheel and clutch so will go with a dobbelt stage 4. have been working on the heads and mr. M-flow here in denmark have done some nice welding to them and thay now have 5 bolt rocker setup. the case is a new autocraft who i have polised inside so we are soon redy to put it together.
the goal is to have the engine in the car with intake and torbo manifold by xmas so i can work on the efi stuff.

Some nice parts!

thanks. engine case back together and soon as a long block. and in my xmas holiday i will build manifold and intake.