|
Title: Problem Installing "Spool" Post by: Ninho/DKM on July 06, 2012, 12:01:27 pm Does anybody tell me why my new spool results wider than superdiff about 0.3mm? I am trying installing this piece of alu in my gearbox and it get stop just i tightening side cover bolts. Is there something that i miss? I used spacer that was in superdiff that i got off thinking both diffs had same dimensions but it seems not! Bearings are fully seated but it does not work.
Does anyone had same troubles? Title: Re: Problem Installing "Spool" Post by: mr horsepower on July 06, 2012, 19:43:44 pm Why not.
because its not a drop in item ;D.but you noticed that already. This is how it works Mesure youre backlash before removing the sd Then mesure youre shim rings on each side mesure youre spool dimensions Then substract the amount of difference that you mesured Then put the fkrr in and mesure youre backlash again you know wat to look for because you mesured it on the sd If youre preload is also correct your good to go. good luck gr henri |