|
Title: Motor plates Post by: Andy Sykes on September 15, 2012, 19:25:03 pm Hi guys anybody got a clue what grade aluminium I should use for a motor plate ?
Cheers andy Title: Re: Motor plates Post by: Red Rooster on September 16, 2012, 16:32:49 pm 6082T6.
If you have any problem sourcing it give me a shout. we can supply it to required size or as a fully cut motor plate. cheers David Title: Re: Motor plates Post by: StrokerMcDell on September 17, 2012, 09:17:23 am How thick are they
Do you need to extend the input shaft for an ally motor plate Cheers Title: Re: Motor plates Post by: Red Rooster on September 17, 2012, 09:51:44 am Everything we have ever made is 1/4 of an inch thick as per rules.they where for v8's not V8's but the thickness is the same.
The input shaft should be fine. there are bits to be gained by modifying the bellhowsing if not. David Title: Re: Motor plates Post by: dragvw2180 on September 25, 2012, 04:04:46 am Might want to think about the starter gear engagement to the flywheel also , whatever thickness is sandwiched between the engine and transmission will move the ring gear causing the starter to not engage. Mike McCarthy
Title: Re: Motor plates Post by: Andy Sykes on September 25, 2012, 07:07:10 am im ok for my aplication a pauter are machining the block to suite :)
|