|
Title: Custom Stainless Exhaust for A1 Turbo Header Post by: Stripped66 on May 05, 2013, 20:22:11 pm Custom stainless steel exhaust, fits the A1 DRD under-the-apron (hide-away style) header. 2.5" tubing, Vibrant resonator, 2 oxygen sensor bungs, 4-bolt T3 flange. All fittings, tubing, and resonator are stainless steel. Top-notch fitment and welding by Bob Cook of Cooker's VW in Maryland. Tucks up between the driver's rear tire and inner fenderwell. The tip of the exhaust is just hidden by the lower edge of the fender (with a T3 .48 AR exhaust housing) for that ultimate sleeper look. Exhaust note is mellow.
The exhaust is in very good condition, with the exception of some fender undercoat that peeled off the fenderwell and stuck to the tube (see pic). If you don't feel like chipping it off, you can't see it when the exhaust is installed anyway. A bit dirty, but I suppose you could polish this up quite nice...but seriously, how vain are you? It sits in the fenderwell and it's not meant to be seen. $200, plus shipping (20"x16"x16", ~20lbs, shipped from South Carolina). Cheaper than the cost of the stainless material to make the exhaust! (http://images.thesamba.com/vw/classifieds/pix/4831082.jpg) (http://images.thesamba.com/vw/classifieds/pix/4831083.jpg) (http://images.thesamba.com/vw/classifieds/pix/4831084.jpg) Title: Re: Custom Stainless Exhaust for A1 Turbo Header Post by: Stripped66 on June 12, 2013, 18:06:15 pm Sold.
|