Title: AN-8 tap borrow or buy Post by: Rocket Ron on October 17, 2013, 14:59:04 pm looking for an an-8 tap to borrow or buy to fit an AN-8 fitting to a aluminum oil cap
will be at shakey on the last week end of October if you are going and can bring one to the track regards Ron Title: Re: AN-8 tap borrow or buy Post by: That's all folks on October 17, 2013, 19:26:00 pm Bring it round Ron, should have a tap to fit.
Title: Re: AN-8 tap borrow or buy Post by: Rocket Ron on October 17, 2013, 23:23:13 pm cheers Jon
see you at the week end Title: Re: AN-8 tap borrow or buy Post by: deano on October 29, 2013, 06:41:05 am Usually, don't you use a NPT (National Pipe Thread) for any type of fitting like this?
Title: Re: AN-8 tap borrow or buy Post by: richie on October 29, 2013, 17:03:07 pm Usually, don't you use a NPT (National Pipe Thread) for any type of fitting like this? Yes I would, usually 3/8 npt to -8 fitting and tap the piece for the 3/8 npt |