The Cal-look Lounge

[attachment=1]Brand new, never ran.. I have had these for about 20 years. Similar heads have been used on super quick, torque street strip machines.. You really don't need bigger valves if the car is going to spend most of it's life on the street. bored for 94mm  See the photos. 1000.00. USD  Any questions ask. Talk to me. Thank you.  

What kind of manifolds Dan? For IDF or IDA pattern? thanks

[attachment=2][attachment=2] Jim, They are for IDAs . I am trying to post pics  but I have downsized and still get an error message. Will try again. bear with me.

Well I got a couple of pictures up, but I think I still don't have it perfected  LOL

Man those remind me of Darrell.  :)

Yeah..and swee' pea, and ratto.

he ran heads almost identical to those on his 1776 with Engle 125/ 1.25 rockers/ 48's that Bryan went 13.20's with. In the green '66

Yeah small valves can make good power. Those mild heads on the 1776 I had when I was the custodian, ran 13.30's.. I have seen heads like these get into the very low 12's in a 2276 street car. 1760 pounds. Also a 2165 that smoked the tires when stomped from idle.. that can was snappy.

Hello,

I take it :-)

PM sended

Best regards
Fabrice