|
Title: Cylinder seating surface Post by: baz on December 24, 2016, 15:11:00 pm I have a slight worry over one of my cylinder seating surfaces. I had a set of cylinders cut to suit my deck height. One one cylinder the cut surface face isn't as wide as the other 3.
(http://i.imgur.com/9HpwQ4n.jpg) Is this gonna cause an issue? Do I need another cylinder to start again? Title: Re: Cylinder seating surface Post by: mikko k on December 24, 2016, 16:12:42 pm I guess that there is 3mm surface or more? No any problems.
Title: Re: Cylinder seating surface Post by: baz on December 24, 2016, 16:18:38 pm I guess that there is 3mm surface or more? No any problems. I measure it at 4mm. Good to go then. Thanks |