|
Title: Holley fuel pump with IDAs Post by: numbnuts on April 02, 2017, 09:15:25 am Hi guys,
For those using a holley blue or red pump with IDAs are you using a pre and post filter or just a pre filter? I read the instructions and it said to run both but I have seen others just run the pre filter. As it tight in the area I will install this if I can simplify the set up I would like to. Thanks Joel Title: Re: Holley fuel pump with IDAs Post by: Mike P on April 06, 2017, 23:33:18 pm I've run a red pump on my old '60 and have one set up on my notch thats currently under construction. I ran a filter before and after as recommended. The pre-pump filter was just that, basically right off of the tank. The post-pump filter was placed in line above the drivers side axle and before a bulk head fitting in the firewall. All of this was done with -8 braided line and Earl's fittings then stepped down to -6 from the regulator to the carbs. I'll try to get some pictures posted of the plumbing for the notchback later, no promises though every time i try and post pictures from my phone they never go through. Worst case scenario DM me a cell phone # or e-mail and I can send pictures if that way if you want. Hope this helps.
Mike Title: Re: Holley fuel pump with IDAs Post by: Mike P on April 07, 2017, 21:49:45 pm Ya, so for some reason I can post off of my phone, load photos but when I submit the post it locks and nothing shows up. Again if you want DM me a cell # or e-mail if you'd like me to get you pictures of my current pump/filter set up.
Mike Title: Re: Holley fuel pump with IDAs Post by: Dominick Luppino on April 25, 2017, 19:27:36 pm I use the Holley 12-125, it's real quite and I pre filter it with a Holley Fuel Filter. It's a 125 GPH, works great!
Title: Re: Holley fuel pump with IDAs Post by: dragvw2180 on May 13, 2017, 16:36:30 pm Nice !
|