|
Title: need a good welder to do a pan half and a heater channel Post by: beetletom on October 10, 2007, 19:55:30 pm oh and to weld the trim holes, but i don't think my balls are big enough :D
in west london. any of you know of any? tried to contact richie, but no reply :-[ Title: Re: need a good welder to do a pan half and a heater channel Post by: Black Sheep on October 10, 2007, 20:53:05 pm If you want to stick it on a trailor drive south west for a hundred miles, you may want to drop this guy a line , I know hes not too busy at the moment but his work is top draw :)
volks.jon@ntlworld.com Title: Re: need a good welder to do a pan half and a heater channel Post by: duckmoth on October 10, 2007, 21:49:53 pm oh and to weld the trim holes, but i don't think my balls are big enough :D GET A MILLER MIG WELDER WITH GAS HOOK UP, THEY ARE THE BEST BUT EXPENSIVE. WE USE AT THE SHOP A LINCOLN SP-125 WITH ARGON AND CARBON DIOXIDE MIX. WORKS GREAT ON FLOOR PANS. THE LINCOLN IS STILL A GOOD WELDER BUT THE MILLER IS BEST.in west london. any of you know of any? tried to contact richie, but no reply :-[ |