|
Title: Increasing from 2180 to 2332 & would it run on 48IDA's? Post by: yut.sin1301 on October 31, 2017, 17:25:59 pm Hi there, My name is Jeen
My 2180 engine just gone pop, case and number one piston are destroyed but everything else is savable. I was going to up my engine a little by getting 94 mm case and matching pistons, but i had a thought about maybe ทางเข้าufabet (http://www.ufa365.com/สมัครufabet/) increasing the crank as well to a 84 mm and running 2332 instead? My worry is budget is tight and I would need all my original engine parts, and to run the engine on my original 48 IDA webbers? Would they be up for the job? สมัครufabet (http://www.ufa365.com/สมัครufabet/) My original engine spec was bugpack 92mm crank and case ufabet (http://www.ufa365.com/สมัครufabet/) Scat 1.4 rockers CB super race rods 5 inch FK89 cam & straight cut gears 48 IDA ' s Thanks in advance Title: Re: Increasing from 2180 to 2332 & would it run on 48IDA's? Post by: BeetleBug on November 02, 2017, 08:09:27 am Absolutely no problem at all yut.sin1301. 48IDA`s support up to 250hp.
Best rgs BB Norway Title: Re: Increasing from 2180 to 2332 & would it run on 48IDA's? Post by: Neil Davies on November 02, 2017, 18:19:41 pm As Kalle says, 48IDAs are perfect, but as you say you are on a tight budget, I'd keep the crank and rods any just go for a 2276. You know the history of them, they're presumably already balanced, and there's a little more room in the case. You'd be forking out quite a bit of money for an extra 58cc...
Title: Re: Increasing from 2180 to 2332 & would it run on 48IDA's? Post by: neil68 on November 02, 2017, 22:48:53 pm When I increased my 2017 cc to 2332 cc, I used Mahle 94 cylinders that were trimmed to fit the 90.5/92 holes in the block. Ran them for 10 years without issue in my 12-second street-strip Beetle. Your 5” rods might be too short?
Title: Re: Increasing from 2180 to 2332 & would it run on 48IDA's? Post by: runningmonkey on November 17, 2017, 13:24:13 pm Yes your rods will be to short
I have just done the same going from 2180 to 2332, using 84mm crank on 94mm B&B I had to change my rods to 5.5 inch Title: Re: Increasing from 2180 to 2332 & would it run on 48IDA's? Post by: prohero on May 21, 2018, 04:31:03 am Yes your rods will be to short I have just done the same going from 2180 to 2332, using 84mm crank on 94mm B&B I had to change my rods to 5.5 inch I like your idea. ;D |