|
Title: Not enough end play at flywheel Post by: j-f on May 14, 2008, 20:48:48 pm Yesterday, I check the end play of the engine I'm building for my 68.
I found a play of 0.27mm with 2 shims of 0.24mm. So, I need a 0.17mm shims to have the ideal play. But, the thinner shim available is 0.24mm. What have I do wrong? ??? I was thinking of a wrong size of bushings, but the crank turn freely. Title: Re: Not enough end play at flywheel Post by: Udo on May 14, 2008, 21:17:11 pm Hi
what crank and flywheel do you have ? I would cut the flywheel as much as you need to get the right endplay with 3 shims . Udo Title: Re: Not enough end play at flywheel Post by: Shubee2 (DSK) on May 14, 2008, 21:19:59 pm Yesterday, I check the end play of the engine I'm building for my 68. how much end play do you have with no shims?I found a play of 0.27mm with 2 shims of 0.24mm. So, I need a 0.17mm shims to have the ideal play. But, the thinner shim available is 0.24mm. What have I do wrong? ??? I was thinking of a wrong size of bushings, but the crank turn freely. Title: Re: Not enough end play at flywheel Post by: Germanlkmanx on May 14, 2008, 21:45:57 pm Let me guess. Are you using a LEPE 69mm crank? I have had to do this many times when forced to use those cranks. I would take 0.010" off the flywheel thrust face and re-shim from there...
tom. Title: Re: Not enough end play at flywheel Post by: j-f on May 15, 2008, 06:38:07 am I use an stock crank with a stock 200mm flywheel. Machined for 8 dowels.
Without shims, I have 0.80mm. |