|
Title: AN6 / AN8 fuel line question.... Post by: jamiep_jamiep on August 13, 2009, 14:46:06 pm Well my old engineering tutor used to tell me the only stupid question was the one you didn't ask... so here goes -
I have some used fuel fittings on a holley that I need to link into my existing fuel system - how can I tell what size they are here so I can buy additional fittings? Anyone give me a clue? Thanks. Title: Re: AN6 / AN8 fuel line question.... Post by: Hotrodvw on August 14, 2009, 05:43:36 am Use this chart. JIC is interchangeable with AN parts.
http://fittingsandadapters.com/saej537flarj.html (http://fittingsandadapters.com/saej537flarj.html) Follow the thread ID and OD measurements. ;) Title: Re: AN6 / AN8 fuel line question.... Post by: Russell on August 14, 2009, 06:42:27 am a 19mm spanner is required for -6 fittings for the center part
Title: Re: AN6 / AN8 fuel line question.... Post by: SteveW on August 14, 2009, 07:05:21 am a 19mm spanner is required for -6 fittings for the center part It depends what brand you buy and what degree fitting! There normally imperial size too! Took me a while to figure it all out ::) :D Title: Re: AN6 / AN8 fuel line question.... Post by: jamiep_jamiep on August 14, 2009, 08:18:34 am Thanks guys! And thanks martin for the pm.
|