|
Title: Oxyboxer questions? Post by: FIDDE on October 25, 2009, 22:09:52 pm I have some questions about an oxyboxer case,first is it possiple to machine down the deck 10mm on
both sides to get the right deck.And does the 94 bore typ1 cylinders fit in the case without machine job.Im aware of the wider headstuds. /F Title: Re: Oxyboxer questions? Post by: stealth67vw on October 25, 2009, 22:53:46 pm Your more likely to get more responses here:
http://www.shoptalkforums.com/viewforum.php?f=37&sid=f97e5332057f411fde1947e4fd62cc88 Title: Re: Oxyboxer questions? Post by: RMS Boxer Service on October 25, 2009, 23:13:25 pm I have some questions about an oxyboxer case,first is it possiple to machine down the deck 10mm on No milling the case down 10 mm on each side will weaken the case too much in numerous places.both sides to get the right deck.And does the 94 bore typ1 cylinders fit in the case without machine job.Im aware of the wider headstuds. /F No the 94 mm type 1 cylinders wound't fit, but due to the wbx case is wider the cylinders have to be machined in the case end. The cylinders can now be machined to fit the spigot bore in the wbx case. /Rolf Title: Re: Oxyboxer questions? Post by: FIDDE on October 26, 2009, 12:33:58 pm Ok... thanks for the info :) I have a Demello 84 race crank and CB 5.5 H rods that im going
to use.Maybe it's to much job to go on a oxy,im looking at different case options. Title: Re: Oxyboxer questions? Post by: RMS Boxer Service on October 26, 2009, 17:00:31 pm Ok... thanks for the info :) I have a Demello 84 race crank and CB 5.5 H rods that im going It's a near perfect combo for an oxy boxer :). Machining the cylinder to fit the spigotto use.Maybe it's to much job to go on a oxy,im looking at different case options. bores and deck height is the same as any other combo. Just go for it ;D /Rolf Title: Re: Oxyboxer questions? Post by: Udo on October 26, 2009, 19:30:57 pm 94mm Type 4 cylinders fit in the WBX case . You only have to do some work on them
Udo Title: Re: Oxyboxer questions? Post by: FIDDE on October 27, 2009, 10:00:45 am Do they seal properly? typ1 cylinder
(http://web.archive.org/web/20010802143038/http://www.gearheads.dk/oxybilleder/oxy_cyls.JPG) Title: Re: Oxyboxer questions? Post by: RMS Boxer Service on October 27, 2009, 17:10:50 pm Yes they seal very fine as long as the machine work is done correctly. Sealing surfaces in the top and in the botton of
the cylinder have to be parallel. On the 101,6x86 oxy engine I have build for a friend we ended up with less sealing surface than 94 mm cylinder proberly will have and the engine is not leaking. /Rolf Title: Re: Oxyboxer questions? Post by: FIDDE on October 28, 2009, 11:15:48 am Ok,,what´s the difference between the bearings,can i use all year models of the case 86-91.Is it the early case that have
1mm+ on the flywheel bearing for typ1 crank,or is it the same? /F |