|
Title: Had some port work done :D Post by: Lukej on March 30, 2017, 20:45:47 pm 42mm x 37mm 050s
72cc intakes 50cc chambers 94mm pistons Deeper spring pockets 86b (http://i1199.photobucket.com/albums/aa476/lukemj/FB_IMG_1489915521445_zpsujvwkylg.jpg) (http://i1199.photobucket.com/albums/aa476/lukemj/IMG_20170313_185352_zpsxhtrjvrg.jpg) (http://i1199.photobucket.com/albums/aa476/lukemj/IMG_20170313_185337_zpstzxshel8.jpg) (http://i1199.photobucket.com/albums/aa476/lukemj/IMG_20170313_185426_zpsbdtsmnhr.jpg) I made a silicon plug too, gives a nice indication on the port shape and makes measuring CSA much easier... manifold wants opening up a little about 3" up from the flange I reckon... seems to close up a bit then open out again at the head before tapering back down. Title: Re: Had some port work done :D Post by: leec on April 01, 2017, 12:54:29 pm Who did the port work for you?
Lee Title: Re: Had some port work done :D Post by: Lukej on April 01, 2017, 16:38:37 pm Danny Wharton/Reich speed.
I limited him on what he could do mainly down to cost. He fitted new guides, ported and recut seats. Looks good to me. Title: Re: Had some port work done :D Post by: leec on April 01, 2017, 18:09:02 pm Nice work Danny :)
|