|
Title: Scrap case/block Post by: spoolin70 on December 07, 2022, 05:20:58 am Hi everyone
I’m looking for a type 1 case/block to use as a mock-up for my real (expensive) engine. Can be cracked, have insides smashed, pulled head studs, big holes etc. Just needs the mounting points in place so I can attach it to the engine plate. I was borrowing a case but the owner needs it back so I’m looking for a case, preferably UK to attach my wooden cylinders to (cheaper than pauters :D) and some old heads to give me the correct dimensions to work out a turbo header and clearances - 6inch rods mean she’s wide !! Here’s what I’ve been using till now … [attachment=1] Thanks Darren Title: Re: Scrap case/block Post by: richie on December 07, 2022, 09:27:22 am Hi everyone I’m looking for a type 1 case/block to use as a mock-up for my real (expensive) engine. Can be cracked, have insides smashed, pulled head studs, big holes etc. Just needs the mounting points in place so I can attach it to the engine plate. I was borrowing a case but the owner needs it back so I’m looking for a case, preferably UK to attach my wooden cylinders to (cheaper than pauters :D) and some old heads to give me the correct dimensions to work out a turbo header and clearances - 6inch rods mean she’s wide !! Here’s what I’ve been using till now … [attachment=1] Thanks Darren I got a couple, pm me address and can figure out posting one to you :) Title: Re: Scrap case/block Post by: spoolin70 on December 08, 2022, 03:22:45 am It’s a Christmas miracle :D
PM sent Thanks Richie |