Hi,
this is a very special question about fitting some pistons of a foreign vehicle...in a VW engine...I want to build a screamer engine, small displacement, with high rpms and i have to, such Johannes P. said,build the engine width as short as possible...
So i want to use pistons with a lower compration high..I have found some pistons from VW,opel vauxhall or BMW wich have 85,5mm-87mm but with KH of about 26-29mm...there are really nice...BUT they have all 20-21mm piston bolts...So with which material is a bushing made....And could it fitt and fuctioned with smaller bolt instead of 22mm for such high HP/L?
That is only all for high rpm and low rotated masses..
![Grin](http://cal-look.no/lounge/Smileys/default/grin.gif)
here are some photos of my TBs(45mm Diamter,50mm intake)..i will use one Tbs per site, kadron manifolds....Megasquirt Injection...
Bye
Tom