I'm not sure if this is the right Place for this post, but here goes. I had A-1 fab a dual QP muffler for my Berg 933S header. After I finally got my Berg 2110 engine in the car the muffler doesn't fit.
![Sad](http://cal-look.no/lounge/Smileys/default/sad.gif)
Take a look at the pictures below. The muffler flange is just a little low and when you try and bolt the muffler up the muffler bodies hit the bottom of the fenders. I talked with Manuel at A-1 and he's willing to modify the muffler but I'd have to send him the header and muffler to make sure it all fits (I live in Florida). It's not A-1's or Berg's fault as I think the header collector location and angle for these headers may have changed over time and it was impossible for A-1 to know which one I had. A-1 did come close though! Anyway, does anybody have any ideas on how i can make this work without cutting and modifying the header collector or muffler?
![Huh](http://cal-look.no/lounge/Smileys/default/huh.gif)
I had a straight collector spacer made but that didn't work either.
![Sad](http://cal-look.no/lounge/Smileys/default/sad.gif)
I don't want to sell the muffler to anyone because they'll probably have the same problem and they would get pretty pissed at me.
![Embarrassed](http://cal-look.no/lounge/Smileys/default/embarrassed.gif)
Also, if anyone has an old Berg dual or even single QP in good shape for a 933S header that they may want to sell let me know. Open to any ideas, Thanks!