Ghia rust repair

[danny gabbard]

The new and old peice and the hole that was cut out and ground and filed

[danny gabbard]

Welded in and ground down

[danny gabbard]

Shot of the inside.

[Speed-Randy]

Hey Danny, you need to drill a hole in the cross center to drain water, That is a nice peice right there

[jaqo]

I have a question - hope you can help.
i  can see you seam welded this thing - how do you prevent it from warping?

[danny gabbard]

Any time you weld or heat panels up they warp or move around some. Now to your question, If you grind weld down to same thickness as the material your welding and hammer lightly on seams of weld it will start stretching the welds that shrank from welding and stretch alittle and bump with dolly till low spots go where you tell them. I hope that helps a little.

[Harry/FDK]