|
Devils speedshop
|
 |
« Reply #120 on: February 17, 2012, 11:44:30 am » |
|
No not yet, there are a few things that needs to be made befor firing up the Beast.
|
|
|
|
|
Logged
|
|
|
|
|
Devils speedshop
|
|
« Reply #121 on: February 21, 2012, 11:35:51 am » |
|
Been working on fitting this mother fucker wide engine into my car...
|
|
|
|
|
Logged
|
|
|
|
Anders-DK
Full Member
Posts: 160
Less is more
|
|
« Reply #122 on: February 22, 2012, 16:32:42 pm » |
|
Been working on fitting this mother fucker wide engine into my car...
Looks huge Kriller  what about the wheelie bar and all the oil hoses and the oil filter? |
|
|
|
|
Logged
|
Best Regards
Anders
The Priest Racing
PR-Chief Team Angora Racing
|
|
|
Big Power
Jr. Member
Posts: 61
|
|
« Reply #123 on: February 22, 2012, 19:57:07 pm » |
|
That engine is not that much wider than your old one, only .300 wider per side. I think the difference is the Terminator carburetors. Looks good Christian!
Pat Downs
|
|
|
|
|
Logged
|
|
|
|
|
sonic
|
|
« Reply #124 on: February 22, 2012, 20:15:18 pm » |
|
Super bil og super motor .. gratulere christian .. Malmø må være et "must" ..
Mvh
Erich
|
|
|
|
|
Logged
|
|
|
|
|
Devils speedshop
|
|
« Reply #125 on: March 18, 2012, 21:07:03 pm » |
|
Are mounting the Datalogger from RPM Performance.
Christian Ulberg
|
|
|
|
|
Logged
|
|
|
|
|
Devils speedshop
|
|
« Reply #126 on: March 18, 2012, 21:09:40 pm » |
|
A few more pic.
|
|
|
|
|
Logged
|
|
|
|
Big Power
Jr. Member
Posts: 61
|
|
« Reply #127 on: March 19, 2012, 20:19:23 pm » |
|
Are mounting the Datalogger from RPM Performance.
Christian Ulberg
Christian, Before you get too far with the data logger, consider moving it away from your MSD 7AL2. If you read through the RPM data loger instructions, it says to keep it away from ignition boxes. The dataloger will pick up noise and corrupt all your log files during a run. I know this because I did the very same thing as you and had to move it 18 inches away. |
|
|
|
|
Logged
|
|
|
|
53
Newbie
Posts: 46
|
|
« Reply #128 on: March 19, 2012, 22:33:11 pm » |
|
The problem with Malmø is that it is to expensiv to drive there, a trip to Gardermoen or bitburg is cheaper..
Christian
[/quote]
What is expensive about Malmö?
Is iit the ferry or bridgees that are to expensive?
/Mikael
Christian,
There is a test`n tune weekend at Gardermoen May 5 - 6. Full prep of course. I will be there and my hope is that we can make a good size VW camp area. It would be a pleasure having you over and please let me know if you consider it.
This is the Scandinavian VW race schedule so far:
- Mai 5-6, Test`n tune Gardermoen
- Mai 19, VWOpen Finland
- Juni 9-10 Bug Run
- Juni 9-10 Turbo Town Shootout Kjula
- August 4-5 Bug Run Classic Tierp
- August 17-19 SCC
- September 1-2 Turbo Town Shootout 2 Kjula
- September 7 Gatebil 201m - se under for info
- September/Oktober: Night of Fire, Tierp
It is a busy schedule and I can highly recommend the Kjula races and especially the Turbo Town Shootout. Tierp is of course world class.
Best rgs
BB
[/quote]
|
|
|
|
|
Logged
|
|
|
|
|
Devils speedshop
|
|
« Reply #129 on: March 20, 2012, 09:42:19 am » |
|
Yes the problem is the bridges thety are expensiv with a truck like mine plus the 200 liter diesel to drive there.
Ill see what I can do, it whould be great to test on Gardermoen in may.
Christian
|
|
|
|
|
Logged
|
|
|
|
|
Fasterbrit
|
|
« Reply #130 on: March 20, 2012, 10:15:19 am » |
|
|
|
|
|
|
Logged
|
|
|
|
|
BeetleBug
|
|
« Reply #131 on: March 20, 2012, 10:46:05 am » |
|
... he said and looked at the stinger. |
|
|
|
|
Logged
|
10.41 - 100ci - 1641ccm - 400hp
|
|
|
|
|
|
BeetleBug
|
|
« Reply #133 on: March 20, 2012, 12:02:39 pm » |
|
Christian, let me know if you need any information with regards to the test`n tune session at Gardermoen in May. Their new website is up`n running but they have still not opened the registration or posted the rules for the event. As soon as its up I will post the link here if it is OK for you.
-K-
|
|
|
|
|
Logged
|
10.41 - 100ci - 1641ccm - 400hp
|
|
|
|
sonic
|
|
« Reply #134 on: March 20, 2012, 12:25:33 pm » |
|
I do agree that Malmø is expensive for you , its about 320 DK for the eurobridge and 270 DK for the big belt !! (normal car)
Is a shame realy !!.. but consider the rest , Norway is by far cheap !!!
Regards
Erich
|
|
|
|
|
Logged
|
|
|
|
|
Devils speedshop
|
|
« Reply #135 on: March 20, 2012, 12:38:16 pm » |
|
It will cost around 2300 DKr for the bridges and 2000 dkr in Diesel plus 500-1000 to drive there.
Yes please post when you know some more about it.
Christian
|
|
|
|
|
Logged
|
|
|
|
|
sonic
|
|
« Reply #136 on: March 20, 2012, 23:13:00 pm » |
|
Christian ; Get some sponsors !! , half the fun is getting there....have a nice summer ...
Reg
Erich
|
|
|
|
|
Logged
|
|
|
|
|
|
|
Jonny Grigg
|
|
« Reply #138 on: October 11, 2012, 09:00:38 am » |
|
Hi Christian,
From reading a thread on the Pure Racing forum discussing the 'JCL steering mod', I remembered that your car had it done when it was built by Shawn Geers back in the mid 90s. I dug out an old 1997 copy of Volksworld the other day that had the original review of your car in it but it is hard to see the system in any detail. Would you mind if you you could post up a couple of pictures of the front end and the steeing system of your car?
Thanks very much
Jonny.
|
|
|
|
|
Logged
|
No Compromise. O/FF111
|
|
|
|
Devils speedshop
|
|
« Reply #139 on: October 11, 2012, 11:32:29 am » |
|
Sure ill see if i can do it tonight.
But its just a bar betwen the spindels and one rod to the sterring rack pretty simple but exffectiv. We also did it on you air ride cars. So you don't get the tow in and out on the wheels no matter what height its in.
Christian Ulberg
|
|
|
|
|
Logged
|
|
|
|
|
Udo
|
|
« Reply #140 on: October 16, 2012, 18:55:45 pm » |
|
Do you think you can race next year ??
Good luck Udo
|
|
|
|
|
Logged
|
|
|
|
|
Devils speedshop
|
|
« Reply #141 on: October 18, 2012, 09:56:39 am » |
|
Don't know yet, the engine is pretty fucked up and im still fighting with Pat about it.
It will need some new parts that I can't affort right now, and im starting to loos intress in it all because of all this shit.. but you will proberly be abel to read that soon...
Christian
|
|
|
|
|
Logged
|
|
|
|
|
Devils speedshop
|
|
« Reply #142 on: October 18, 2012, 10:03:19 am » |
|
[ Attachment: You are not allowed to view attachments ]
|
|
|
|
|
Logged
|
|
|
|
|
BeetleBug
|
|
« Reply #143 on: October 18, 2012, 14:16:44 pm » |
|
Don't know yet, the engine is pretty fucked up and im still fighting with Pat about it.
It will need some new parts that I can't affort right now, and im starting to loos intress in it all because of all this shit.. but you will proberly be abel to read that soon...
Christian
So sorry to learn about your problems Christian! Please do not give up because there is so many of us that would like to see you and your car back out on the track again! Best rgs BB |
|
|
|
|
Logged
|
10.41 - 100ci - 1641ccm - 400hp
|
|
|
|
bang
|
|
« Reply #144 on: October 18, 2012, 14:25:46 pm » |
|
yes and we are redy to help..
|
|
|
|
|
Logged
|
|
|
|
|
Devils speedshop
|
|
« Reply #145 on: October 18, 2012, 18:32:17 pm » |
|
I try to keep up and be positiv but its pretty hard when you have spend a ton of money already and with this result, the reason for using all this money where not to be in the situtation that i am now.
Right now it 50/50 if i will keep racing, even befor starting for real. But it hard to see all the stuff just stand there and not be used, a racing truck all the tools and gear i spend all the money on. Not funny when you feel like it whould be bette off without it.
Christian Ulberg
|
|
|
|
|
Logged
|
|
|
|
|
Jonny Grigg
|
|
« Reply #146 on: October 19, 2012, 18:29:11 pm » |
|
Thanks for the pictures Christian, much appreciated.  |
|
|
|
|
Logged
|
No Compromise. O/FF111
|
|
|
|
The Cal-look Lounge
Author
