Cheap 1600 turbo (Estonia)

Hi everybody.
I bougth this car few years ago. It´s my first aircooled car. It was without an engine and hasn´t run for almoust 10 years

Then I started working with floor. I cleaned it up and it was full of holes. I cutted it out and replaced it with a sheet metal.

Then I bought this engine:

...and started tuning it:

I got it running. With 0,4bar it moved a little....it was my first running with beetle and it was fun. Then i installed manual boost controller and noticed that this turbo will not boost more than 1 bar. With 1bar of boost it killed my clutch quickly and I took the engine off with all turbo stuff....When the engine was tooken off I cutted the ass off and made some sandblasting and painting. Installed little cooler and put that together again.

I got it running but first gear was missing

I started with second with some wheelspin and it made 14,9 with 155 top speed with 1bar of boost. I wanted to run faster but the turbo was busted and didn´t boost more than 14 PSI with closed wastegate. I repaired the gearbox and installed another turbo (last one came from 2,0 saab engine and new one came from bmw 324) I tested near my workshop in town and it moved deam good with first 2 gears....I just couldn´t hold back and tried it every day....about 25km totally with first 2 gears because it´s not street legal and i could drive only around my workshop.
On the next eavent I went to track and it moved as good as last 25km but at the end of second gear it boosed a-lot more than I wanted....about more than 2 bar. I changed it to third gear and boost went ower 2,5 bar. it couldn´t ignite and it didn´t move at all.....I let the gas down and it moved a little because boost came down but with 4th gear boost went up again and it didn´t move. top speed was only 150km (less than with 14PSI boost and without 1st gear) but time was 13,9

I took the engine off and 2 pistons were busted
I wanted to build 1914 for next year but I think that I could be at least a second faster with my 1600 than this year and I have to get to 12s before building a new engine

So I will put that back together with used parts again and try to be faster next year.

Boost went up because I didn´t turn back the manual boost controller with new turbo and I didn´t made a testrun. With high boost it was lean because of my ecu. It has only 250kpa map sensor. intake temp was deam hot too ~68C

For next year I´m going to cut off some ugly stuff....like tail wing and a scoop on a hood. Maybe I´ll paint it over. I´ll build another stock engine and start pushing the boost up not start with closed wastegate like last year. I need some brakes too. Last year I had 4 drum brakes and I couldn´t warm up my old tyres. I need some shock absorbers too...it starts hopping when I start. I´m going to install lights and some wires for them. I think I have to modify my megasquirt too. launch and flatshift would be good. I have to remove edis then. (A-lot to do in next 3-4 months.