What size of and type of fuel line and pump works best with 2L plus IDA Motor

[Russell]

What size of and type of fuel line (bore diameter) and pump works best with 2L plus IDA Motor

I was thinking about useing a Holly 97 PPH "RED" and some 7mm aeroquip hose and fittings but wasnt sure if this would provide enought fuel for 2332cc drag motor ?

Any suggestions appreaciated.

Russell

[Zach Gomulka]

The Holley pump will support it! I would consider some larger line though.

[Bill Schwimmer]

Yes ,the Holley pump would be fine. How much power do you think it would make ?  I too think that 7mm line is a bit small.  If you are using steel braided line -8 to the regulator & - 6 to the carbs would work fine. If you plan on making more than about 230 or so hp you might take a look to see what others are running to support that power level.  Have fun   Bill

[Russell]

Bill Thanks

Yes Im planning to use -8 for both the tank to centre chassis fuel line and -8 all the way to the carbs, It 2332cc with a 221.6BHP

see below.