This is the spec
69mm 8 dowel crank and flywheel
4 spring clutch friction plate
Kennedy 1700lb pressure plate
Scat 3/8 I beams rods with ARP bolts
C45 camshaft
90.5 B and Ps
041 heads 40X37 mild port with twin springs
Scat 1.25 rockers
Equalizer pulley
Full breather system
Compression 10.0:1
CB deep sump
Full flowed oil with a new fram recently fitted
1.5 merged exhaust header
Empi 009 dizzy
Flame thrower 3 ohm coil
Taylor spiro-pro leads
New 36hp scat fanshroud from speedshop, no outlets
Internal reg alternator
40 idf webers with hex bar linkage
All the tinware has been powder coated black, apart from the rear piece that goes over the exhaust.
Stainless tinware screws.
I have had some jetting probs, but they're sorted now and it needs tuning properly.
I would assume it's putting out about 120/125 hp???
Sensible offers please, try me you might be surprised
I'm selling cos i want to get my bug resprayed, i can then run it it round on a little 1200 untill i get my bigger motor in the spring.
Pic taken tonight
The Cal-look Lounge
Author
