The Cal-look Lounge
Welcome, Guest. Please login or register.
Did you miss your activation email?
February 21, 2019, 15:16:54 pm

Login with username, password and session length
Thank you for your support!
Search:     Advanced search
339835 Posts in 26904 Topics by 6273 Members
Latest Member: Penfold
* Home This Year's European Top 20 lists All Time European Top 20 lists Search Login Register
+  The Cal-look Lounge
|-+  Cal-look/High Performance
| |-+  Pure racing
| | |-+  Rear torsion bars upgrade
« previous next »
Pages: 1 [2] Print
Author Topic: Rear torsion bars upgrade  (Read 9145 times)
Hero Member
Posts: 5220

« Reply #30 on: November 27, 2018, 08:44:08 am »

Wow this is a timely thread for me, when installing large torsion bars what angle do you install them at (ie preload) I'm guessing 17deg would be wayyy to much?

I set them with No pre load, spring plate sits just off the factory stop/cast housing unless you want car to sit lower

Good parts might be expensive but good advice is priceless Wink

Rev6, complete waste of money!!!!
Jr. Member
Posts: 61

the Netherlands

« Reply #31 on: December 17, 2018, 09:40:39 am »

thanks a lot! Any recommendations on torsion bar size? 1957 oval windows run a 627mm long 24mm bar. Running a 60hp engine, so nothing wild.
Pages: 1 [2] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!