2388 cc Pro Stock Race Engine incl ignition - SOLD

[johandryselius]

Hi!

The car and gearbox is sold - engine for sale - 10 passes only in total - all modifications and build by Johannes Persson - JPM "at its best"!!

ENGINE - 2388 cc Type 1 - 302,5 HP at 8400, torque 294 Nm at 6600 (there is probaly more in it since we had a little slip on the dyno):
 Case: AutoLinea
 Crankshaft: SCAT flanged billet 86 mm T4 all mains
 Flywheel and clutch: SCAT with RLR Rev 6 clutch set-up - single disc
 Rods: SCAT 5,7” H-beam
 Rod bolts: Carrillo SPS, 12 point head
 Cylinders: JPM
 Pistons: 94 mm JE ultra low JPM
 Camshaft & Gears: JPM Raptor custom grind 17,35 mm lift, flat tappet, Magnum gears
 Lifters: JAYCEE tool steel
 Cylinder head studs: Raceware Hi tensile 8 mm
 Heads: JPM MS 250, CR 15,4:1
 Rockers: JPM 5 point
 Valves & Springs: Manley Titanium 48x38 mm, Oteva springs
 Retainers: Titanium
 Pushrods & Tubes: Manton double tapered, JPM tubes
 Carbs: Gene Berg 58’s on welded angle flow manifolds, 50 mm venturi, Teflon coated by Tommy Tc Costello , JayCee linkage
 Oiling: CB 4 Gear dry sump, special case modifications, JayCee bypass
 Distributor: JAYCEE crank Trigger
 Pick-up: JAYCEE crank trigger with with alternator combo
 Exhaust: CSP Wasp 3

Ignition:
Ignition box: MSD 7 AL 3
Pro Power Coil


One new extra disc for the REV-6 included.

11000 euros or offer

Johan - johandryselius@mac.com

[Udo]

That is cheap - good luck for the sell

Udo

[johandryselius]

Thanks Udo!
It is!

[johandryselius]

Any offers!?

[johandryselius]

New price!

[johandryselius]

Sold!