51.5 webers ???

[Russell]

Guys

Q1: apart from CB performance does anyone else stock these, i seem to think Empi did them as well ??

Q2: Do the bolt on to 48IDA manifolds ? as i cant seem to find manifolds for 51.5s ??

Any advise greatly appreaciated, cheers

[Frank LUX]

Answer to Q:2 Port them if you can't find them...

Frank

[Frank LUX]

BTW: I think EMPI casted the 51.5 IDA's as well....

Frank

[71CALRIPPER]

i am sure Jack C would ?

[The Burnout King]

PM Sent....

[Joe_G]

Got mine from Vee Dub parts Unltd with all the mods done

[SteveW]

The best ones to buy are the JayCee 51.5mm IDA's, I'm sure it was all over cal-look.com that the empi ones were crap! CB or Vee Dub parts and of course Jack himself are the only stockists as far as I know.

Shawn Geers may also do them(?) but I think his main carbs are the bigger Terminator II carbs..

[Udo]

Russel

I do the work too if you don't want to ship them so far . Main thing is that you cannot bore every 48 to 51,5 because of the progrssion hole of the idelescrew .
I use my own manlfolds for Type1 heads and CB's for superflows .

Udo

[Russell]

Udo

Its for the 3litre aprm motor i have, i need to check the heads to see that the manifolds i have are 48idas, if so Ill give you a call, please pm me your number, cheers

Dom, Thanks if i can get them in europe it will be quicker, will let you.

All, Thanks

[Udo]

Pm sent

For your engine you need all done , bore for 51,5 , larger float chamber , bigger venturis , cut the auxiliary venturi and some good velocity stacks . I do diffenet versions , depends on engine size and needs . Most of the older carbs can not be bored to 51,5 only smaller .

Udo