if you plan on cutting the dash and make a completely new one i personally would go with a aluminium pannel and fith the gauges in that one. but i would put the radio and certainly the equalizer under the dash, just in case you want to fit a different one later.
if it is all metalwork you can keep the glovebox, because there isn't much storing place in the beetle. try to find a pic of Dave Kanase's car and Lee Gong's car. two dashes i personally like for the two different ideas.
Nicolas and Fabs, You both have seen my dash, I don’t know if you remember it. The things that bother me the most is the stupid tach holder that I transformed into an ipod holder and the two chrome dots on the left and the right of the holder. Those dots cover 2 holes in the dash were normally the buttons for the heater are located. Bacause I removed all that I have not the two holes.
I can’t remove the holder because the paint on my dash underneath the holder is damaged. I’m looking for a solution to cover up that spot on the dash.
Maybe you guys have better ideas… put some switches in it (so I cover 2 of the 3 holes) but what with the space in the middle were the holder used to be, put a “empi do not lower” windows…plaque over it… cut up the dash and install a equalizer?
I’m not sure about it…
My first thought was to put my autometer tachs there, that would be nice, but the place on the dash is too small for that… Maybe I can search the smaller tach’s and put some extra tachs there. (if the smallest ones from autometer fit that place???) and what does autometer sell in the smallest models? I’m not planning to install 3 amp or voltage tachs…
Every thought or hint is more then welcome…