cooling tin with jp motorsport cylinder heads

[bang]

have anyone tryed to fit cooling tin with jp heads? do you use s/f tin or modyfi stock?. my engine is a oxy boxer with 30 hk fan house. and i use 5,7" rods so it is a bit wider than stock..
if anyone have pictures i would like to see pictures.. 

thanks.

Peter Bang
Denmark
"Big Bang Racing"

[Roman]

I have done it but I had very low pin height, so it was narrower than stock, but on the other hand: A wider engine does only affect the case side of the cooling tin and and almost every stroker has the same problem.
The JPM heads are like any Superflo/Competition eliminator: They are very big around the intake manifold. Cut/hammer and take your time, it is easier to cut twice than weld back material again.