Snap Shots for Sheep

[Tony M]

A few photos for you.

[sheep]

That thing is bad ass, how about some engine and tranny specs

[Tony M]

And a few more

[Tony M]

And some more

[sheep]

Ok that thing is badder than i thought, we need a full story on this

[Tony M]

First engine - 1914 - 110 cam - C/W crank - Ported big vale heads, 40 x 35.5 - C/R 8.2 to 1 - Single 40 idf - 1 5/8 header
Engine #2 - 1776 - 120 cam - Stock crank - Same type b/v heads - C/R 9 to 1 - same intake and exh - This one is in now
#3 - Will be a - 2165 - Cam ? - 78 mm - Bug pack rods - Heads will be the same - C/R 8.5 to 9.0 ? - Dual 44 idf's - Exh - same

Bus box - 002 - 930 CV's - Race preped - Sway a Way axles - custom made - 5:14 R&P - Stock gears

13 in of Wheel travel both front and rear - Coil over shocks F/R - C/M frame front to rear - Rack steering - C/M tie rods - Heim ends -

All the good stuf  

[sheep]

Are you using that as a preunner, that bottom picture looks as though you are in Baja

[Tony M]

Are you using that as a preunner, that bottom picture looks as though you are in Baja

We drove all 3 car's in that picture all the from San Diego to Cabo and then back. That shot is in Los Barillos, the fishing resort.  We did sort of build them to do some pre running. The other baja has a 2.0 16v engine in it, radiator in front, coolant lines in the tunnel.  Both cars worked realy good in the dirt , the 2nd day down, we went about 150 miles in the dirt, from a crawl to 3rd gear taped out. THE most fun i have had in years.           

[Sarge]

Are you using that as a preunner, that bottom picture looks as though you are in Baja

We drove all 3 car's in that picture all the from San Diego to Cabo and then back. That shot is in Los Barillos, the fishing resort.  We did sort of build them to do some pre running. The other baja has a 2.0 16v engine in it, radiator in front, coolant lines in the tunnel.  Both cars worked realy good in the dirt , the 2nd day down, we went about 150 miles in the dirt, from a crawl to 3rd gear taped out. THE most fun i have had in years.           

NOTHING beats off-roading..., it'll put a smile on your face every time.  Thanks for sharing, Tony!

[roland]

Nice car!!

Damn i need to find 2 old beard seats to put in my offroader...

[Rennsurfer]

Right on, RACEHEAD. Two bad-assed Baja Bugs. Well set up, too. Baja Mexico used to be so much fun. I miss camping, surfing, skating, and fishing down there. I got getta get back down... if I ever get my finances back in order. Thanks for the inspiration.

[Jim Ratto]

Tony how long until that 94 x 78 is going?

[Tony M]

WTF - your all over the pages today - comming soon to a dirt lot near you  a few more new photos

[Dave Rosique]

   
[/quote]

NOTHING beats off-roading..., it'll put a smile on your face every time.  Thanks for sharing, Tony!
[/quote]



What Sarge said!

Nice car Tony... makes my old swing axle Baja look a bit anemic

~Dave

[Lee.C]

man I HAVE to bring my manx over there!

[Tony M]

We worked on the red Baja last night at the shop - got some new Fox 2.5's for the rear's - getting ready for the next desert race here in 2 weeks - the last pictures were shot just after the last desert race - did 2 laps on the race course - 100 miles - car worked bad ass - getting to use it for what is was built for has been a lot of fun - as we all know we spend a lot of time on our cars and it's nice to be able to put them to work - and get us back home .

man I HAVE to bring my manx over there!

Bring it over and well do it up just for you  - our small race shop can build anything - both baja's were done by us at our shop - this is our new race car that we built - 100% cromoly - even the flat plate - all hand built body - all done in house,

[Tony M]

And some more picts