Lifter bores
max Der Bahnstormerz:
Reaming the bores straight, found a few tight, high spots in them
Then radiused the bore face
Final job was to give each bore a quick polish
These guys should appreciate their new home, next on to crank clearance and valve timing
andy198712:
looks nice! what lifters are they?
max Der Bahnstormerz:
Quote from: andy198712 on May 02, 2016, 10:10:23 am
looks nice! what lifters are they?
Schubecks
nicolas:
nice work. may i ask what machine you use to do this?
i used a very old at work to do this (horizontal mill, don't really know the name in english), most certainly 50 years old.
max Der Bahnstormerz:
Just an adjustable hand reamer, a hand drill and a tool bought from Berg's 25 years ago to face the lifter bores.
Then finished off the bores with 120 grit loosely wrapped around a rod in a drill to hone the bores.
Nothing fancy, just lots of care taken not to remove too much material.
Navigation
[0] Message Index
[#] Next page