Oxyboxer heads question

[Henrik Hagen]

Hello

I looking for cylinder head ideas for my oxyboxer project.
I would like to keep the wbx bolt pattern and a cylinder head that do not cost 2000 $.

I know that the following produces cylinder heads for the wbx bolt pattern:
Remmele
Thorsten Pieper
Jp motorsport
Super flow/ angle flow

I would like a head like the limbach but they are rare and far between.
Are there others that produces a cylinder head for a WBX bolt pattern?

[PPRMicke]

After being covid in the world Has there been a shortage of heads
Thorsten Pieper has none in stock
Remmele lacked aluminum when I talked to them (you can always check
JPM had a set of ms 230 and I was the one to pick them up
Angle flow has Richie W for 4 "
If you look around, prices have gone up sharply on heads
/// Micke

[dangerous]

If you are staying small bore,
you can just re-drill your heads to the WBX pattern.
I did this on my supercharged engine 25 years ago.
The washers that came with my Racewear studs covered the 'now figure eight' holes.

[Udo]

I can get new SauerFlugmotoren heads . But cost more than 2000 . i think there are none to get for that price

Udo

[Udo]

We have now new heads like street eleminators for WBX case    Much cheaper than the Sauer heads. 

[wph]

We have now new heads like street eleminators for WBX case    Much cheaper than the Sauer heads. 

Pictures please,

thanks

Pekka

[Udo]

[ Attachment: You are not allowed to view attachments ] .    I get them bare and can complete like you want.

[PPRMicke]

[ Attachment: You are not allowed to view attachments ] .    I get them bare and can complete like you want.

Hi Udo I am looking for info on your website
  But it was bad with info
So please you can not update because you have so many good things there
I also found old things (photo) like but it was 2012 it now 2021

/// Micke

[johandryselius]

Udo!

Do you have these hads in stock?

Johan