2442/Turbo Marty Staggs Motor

I am selling because its to wild for what I need at the moment, the labor and parts are all paid for so you basically get a new engine built by the best at a reduced cost.

$14500
£ 7,361
Euro 9,220
Nok 73,337

Based on current Exchange rates

Which is a bargain you cant buy the parts for that money let alone the skill of such a builder.

2442 Turbo EFI Motor

CB Case
Comp E Heads 44x40
Crank 88mm Bugpack Flanged Crank + Matching Flywheel
Rods (Pauter 5.7 Chevy journal)
Cam (Staggs Racing custom grind)
Straight Cut cam gears (Competition Engineering)
Pushrods (Manton double taper)
Rockers (Pauter 1.3)
P&C's (94 wiseco w/Cima barrels)
Jaycee pushrod tubes
SLR Lifters
Custom dual disk clutch setup
Custom Revmaster oil pump

Cooling – Charging
DTM Fan setup
Fan (welded balanced)
Alternator kit

Turbo System Ceramic coated – Will get the full specs
Custom Ball Bearing Turbo
Custom header system (stainless steel)
Turbosmart wastegate
Turbosmart BOV
Turbosmart two stage boost controller
Intake manifolds with injector bungs
Fuel rails
Intake system
Custom oil lines with fittings
Modified Berg oil sump
65mm Billet Throttle Body
Misc bungs and fittings

There will obviously be a lot of little parts I haven’t listed but, you get the skill and knowledge of Marty Staggs to build you the Turbo motor above, its in the short block stage, so details could be changed to suit your needs, may be you don’t want to use Fuel injection.

Any other questions please contact myself or Marty