Engine and parts help... mild road engine project

[Paul Bahnstormerz]

Which alu pushrods are you using?

Forgot to mention I'm using Scat 1.1:1 rockers.

Using the pushrods Jim at stateside sells.

I was going to use a single spring but the decision for the lower poundage dual setup I'm using is to help control everything on gas

[Iryanu]

Those alu pushrods must not have been available when my engine got built, I'd rather have those than my "clackers". Not to mention the benefits of the lightened valvetrain. I do prefer setting the valve lash though with the "loose zero". No more feeler gauge dance. Haha.

Then again, not much point in lightening the valvetrain when my engine is all done and tucked up in bed with a mug of cocoa by 5500rpm. Shed a tear for my "bus engine". 

[Nico86]

Thank you for all the infos guys (: